Deliverable 01 · Photo set
Photographs of every defect
Close enough to see the damage, wide enough to show where it sits on your roof.
Victoria, Texas
Victoria TPO Roofing for Commercial Flat Roofs
If your Victoria building's flat roof is baking in the Texas heat, here's how TPO holds up.
ARP installs and services TPO single-ply roofing on commercial flat roofs across Victoria and the Crossroads. TPO's heat-welded seams and reflective surface suit the South Texas sun, and our Victoria office runs the whole system — membrane, insulation, flashings, and the scuppers and drains your warranty depends on. Every job starts with a free assessment and a written scope.
Family owned, locally accountable
COO & President — the father and son behind ARP
Why these credentials are on this page
5,000+
Completed projects
4.9★
300+ five-star reviews
GAF GoldElite Commercial
Manufacturer standing
UNIFLEX Premier Elite
Restoration coatings
BBB A+ · CTRCA Member
Accountability
Why ARP
Why Victoria Property Managers Put TPO on Their Flat Roofs
Most property managers inherit a flat roof they didn't pick, and the first they hear of a problem is a stain over a tenant's suite. That's the call ARP's commercial roofing in Victoria team answers most. On a low-slope roof, the membrane and its seams are doing all the work — and Victoria's commercial corridors, from retail strips to the ag and industrial buildings across Victoria County, run heavily to flat roofs that take the full South Texas heat load.
TPO is our flagship single-ply for that reason. It's a GAF EverGuard system, and we're a GAF GoldElite Commercial contractor certified to install it. The membrane is welded seam to seam with hot air, not glued or taped, so the seams fuse into one continuous sheet, and its reflective white surface throws off solar heat instead of soaking it up. The install is run by our Victoria office, with the install crews we deploy and supervise.
A complete TPO system is more than the membrane. On every Victoria install we run:
- Membrane — GAF EverGuard TPO, hot-air welded seam to seam into one continuous sheet
- Insulation — sized to the deck and your energy target
- Flashings — woven in at every wall, curb, and penetration
- Scuppers and drains — sized for the positive drainage the warranty depends on
We weld TPO for buildings across the Crossroads and down the coast — out to Port Lavaca and Port O'Connor, where Gulf uplift makes every seam and fastener non-negotiable.
On a Victoria flat roof, the TPO seam is the whole job. A hot-air weld either holds through a South Texas summer of heating and cooling every day, or it doesn't — so we probe every seam we weld and hand you the photos. And when the old scuppers and drains can't move the water anymore, we put new ones on the estimate, because positive drainage is a warranty condition, not an upsell.
Randal Williams · COO, ARP Roofing & Remodeling
The Part Most
The Part Most TPO Bids Leave Out: Drainage
A new single-ply roof almost always needs new scuppers and drains. That's not us padding the bill — most manufacturers write positive drainage into the warranty, so ponding water can void the coverage you paid for. Some bids leave the new drainage off to land a lower number. We don't, and we itemize it per opening so you can see exactly what the roof needs.
If your deck and insulation are still sound, a coating can sometimes extend the roof instead of replacing it — see Victoria commercial roof coatings. If the membrane is past saving, we'll scope a full commercial roof replacement instead.
The Right Fit
Is TPO the Right Call for Your Victoria Roof?
TPO is the right call if you:
- manage a low-slope commercial building
- want a documented scope and photo proof your ownership or board can read
- plan to hold the property long term
It's the wrong call if you:
- are choosing on the lowest bid without reading what's under it
- need a crew on the roof tomorrow with no assessment
Estimate your Victoria project
What a TPO roof costs in Victoria
Commercial TPO is priced per square foot of roof area. Membrane thickness, roof access, and the number of rooftop penetrations move the number — price your building against our 2026 Victoria rates, then we'll confirm it on the roof.
| System | Installed / sq ft | Where it fits |
|---|---|---|
| GAF EverGuard TPO / single-ply | $8.24 to $14.42 | Low-slope membrane, heat-welded seams |
| Commercial metal (site-formed) | $11.33 to $18.54 | Standing-seam for steeper commercial roofs |
| Silicone / acrylic restoration coating | $3.60 to $6.18 | Restoration-eligible substrate only |
| Flat-priced commercial repair | $1,500 to $3,600 per job | Priced after an on-roof inspection |
Read the units
Ranges are per square foot of actual roof area — the low-slope or steep surface a crew installs. Flat-priced repair is per job, not per foot. Coating rates assume a restoration-eligible substrate confirmed on the roof.
Price your Victoria roof & book the visit
2026 Victoria rates. About 40 seconds.
Roof area used: 12,000 sq ft — low-slope roofs run close to footprint
Adjust roof size to see your price
Your 2026 Victoria range
Request in — we'll text to confirm
Need it sooner? Call or text (361) 238-4255.
Four things move your number
Driver 01
Roof size and pitch
Steeper means slower and safer, which costs more.
Driver 02
Material
The single biggest lever, and the one you actually choose.
Driver 03
Decking condition
Found at tear-off, photographed, and shown to you before any replacement.
Driver 04
Access
If your roof is hard to reach or the property is tight.
Honest fit check
Is ARP the right fit for your Victoria project?
The best way to judge any Victoria contractor — us or anyone else — is to ask for a written scope, ask who your single point of contact is, and ask when the manufacturer warranty gets registered in your name. If a roofer can't answer those three plainly, that's your answer.
Yes — we're a match
A good fit if you
- Want a roofer your Victoria neighbors have actually used — not a pop-up tent after the last hailstorm.
- Want everything documented and in writing, with photos, before any crew gets on the roof.
- Plan to stay in your Victoria home or hold the property long term.
- Had recent hail or wind damage and want it documented correctly for your carrier.
No — we'll say so up front
Not the right fit if you
- Need a commercial job below our minimum repair scope, or a firm residential repair price over the phone — we quote every repair after an on-roof inspection.
- Need someone to start tomorrow with no inspection.
- Are choosing purely on the lowest bid, without reading the scope underneath it.
- Want a contractor to pay, waive or "take care of" your deductible — a criminal offense in Texas under Business & Commerce Code § 27.02.
We'd rather tell you that on the phone than waste a walkthrough.
No cost, no obligation
Your free Victoria commercial roof assessment
A free Victoria commercial roof assessment costs nothing and comes with no obligation. A project manager inspects the existing membrane, photographs the condition, and gives you a written report on whether a TPO system is the right call for your building.
We check the seams, the flashings, and the drainage a single-ply roof depends on — including whether new scuppers or drains belong in the scope. We won't lowball by leaving them out.
You get the photos and the scope whether you hire us or not, and on commercial work that scope is COO-reviewed before any crew mobilizes.
From assessment to warranty
1
Free Storm Shield Assessment
We measure your roof, photograph it, and document what's actually there — not a curbside guess. You get the photo set whether you hire us or not.
2
Written Scope Before Any Work
You'll see line-item scope, materials, warranty options, and a real number in writing. On commercial projects that document is COO-reviewed. Nothing starts until you've read it.
3
Install and Warranty Registration
A crew led by an ARP project manager does the work, pulls the Victoria permit, and inspects at the key stages — then your manufacturer warranty registers in your name within 30 days.
No fee, no deposit, no pressure. We confirm your address is covered before we schedule — then a project manager walks the roof.
Questions that decide the job
Victoria roofing — frequently asked questions
How long does a TPO roof last in Texas heat?
+
A properly installed TPO roof commonly lasts 20 to 30 years, even under the South Texas heat load. The reflective surface lowers the roof's temperature, and heat-welded seams take the daily expand-and-contract cycling far better than glued or taped ones. Install quality and drainage decide the rest — a roof that ponds ages faster than one that sheds.
How does TPO compare to other flat-roof membranes?
+
TPO is the most common commercial single-ply and our flagship, but PVC and EPDM each have their place — PVC for grease- and chemical-heavy roofs like kitchens, EPDM as a proven rubber membrane. The right pick depends on your building's use, slope, and drainage. For the full membrane-by-membrane breakdown, see our complete TPO and single-ply roofing guide.
Can I restore my TPO roof instead of replacing it?
+
Often, yes. If the membrane is weathered but the deck and insulation underneath are still sound, a silicone restoration coating can seal the seams and add years without a tear-off — no shutdown for your tenants, and the roof you already have stays out of the landfill. It only works over a sound roof, so we run a moisture scan first. See how restoration coatings work and what they cost in our commercial roof coatings guide.
How much does TPO cost per square foot in Victoria?
+
Installed TPO in the Victoria market generally runs about $8.25 to $12.40 per square foot, so a 10,000-square-foot flat roof typically lands between $82,000 and $124,000. Final price depends on your existing roof condition, deck, drainage, and access. Every estimate includes a written scope, deck inspection, and warranty registration.
Do new single-ply roofs need new scuppers and drains?
+
Almost always, yes. On a single-ply system the manufacturer's warranty usually hinges on positive drainage, so your new TPO roof has to move water off the deck through scuppers and drains sized for the job — not just have them present. We quote each opening as its own line rather than folding it into the square-foot number, and we won't quietly delete it to make our bid look lighter. Drainage the warranty requires isn't where a Victoria building saves money — leaving it off is what turns a cheap roof into an expensive one two years on.
Still exploring?
Want the complete guide to commercial TPO & single-ply?
Our statewide commercial TPO & single-ply guide goes deep on materials, cost, lifespan, and how each choice holds up in Texas — the full answers behind this Victoria page.
Explore your Victoria roof
Start where your question is
Every door lands on one written scope — pick the one that fits where you are right now.
01
Victoria Commercial Gutters
ARP installs commercial box gutters, oversized downspouts, and internal roof drainage for Victoria, TX buildings from our Victoria office. Free assessments.
See Victoria Commercial Gutters →02
Victoria Commercial Metal Roofing
If your Victoria warehouse, shop, or storefront needs metal that lasts, here's what to weigh before you sign.
See Victoria Commercial Metal Roofing →03
Victoria Commercial Roof Coatings
If your Victoria building has a sound flat roof you'd rather restore than tear off, here's the honest first step.
See Victoria Commercial Roof Coatings →04
Victoria Commercial Roof Repair
When your Victoria building springs a leak, you need a commercial crew that finds the failure point — not just the wet spot.
See Victoria Commercial Roof Repair →05
Victoria Commercial Roof Replacement
If you manage an aging Victoria building, here's how ARP calls recover versus full tear-off before your reroof starts.
See Victoria Commercial Roof Replacement →Book your free Victoria commercial roof assessment
Photo-documented, with a written condition report in hand — whether or not you hire us.
