How Much Does a Roof Replacement Cost in Texas? By Roof Size and Material

Get a no-obligation ballpark on roof replacement in Texas in seconds, no name, no email required. When you want a firm, address-level number, book a free inspection and get a written quote.

Every honest answer to this question is a range, because your number depends on what goes back on the roof and how big the roof actually is. Here's where each material lands, priced per square foot of roof area, statewide, before any storm or upgrade changes the math.

A roof replacement in Texas runs $4.95 to $15.00 per square foot of roof area depending on material: architectural shingle around $5.50 to $6.00, tile $10.00 to $15.00. A typical 2,000-square-foot home lands near $17,600 to $19,200 for shingles.

Standing seam metal is the one material that isn't in the table above, because it's a different decision with a much longer horizon. It runs $7.60 to $14.50 per square foot and lasts 40 to 70 years in Texas, so the right way to weigh it is cost per year, not cost today.

Because roof area is what you're actually paying for, the cleanest way to see your number is by home size. These are architectural-shingle installed totals at the statewide baseline:

Updated July 2026: statewide baseline pricing. Some Texas markets run modestly higher (roughly 3 to 8 percent) because of steeper pitches and tougher access; your written estimate reflects your own roof, not an average.

Here's the single thing most homeowners get tripped up by: your quote is bigger than your house. Your mortgage statement, your tax record, and your MLS listing all describe your home in living-space square footage. Your roof is a different, larger surface.

Roof area runs roughly 1.3 to 1.7 times your living-space footage, because it includes the garage, the patio cover, the overhangs, and the soffits; then it stretches again for pitch. A steeper roof has more surface hiding over the same footprint. That's why a 2,000-square-foot home has closer to 3,200 square feet of roof, and why multiplying your house size by a per-foot rate under-counts the job by a third or more.

So when a quote reads "3,200 square feet" for your 2,000-square-foot home, nobody padded it. That's the surface a crew tears off, dries in, and covers. If you'd rather not do that math by hand, the roof replacement calculator converts your home size to roof area for you.

Four things do most of the moving between the low and high end of any range:

1. Roof size and pitch. Size is obvious; pitch is the quiet one. A steep roof is slower and more dangerous to work, so anything above a 6:12 slope carries a premium. Texas Hill Country and custom homes feel this most.
2. Material. This is the biggest lever you control. Moving from architectural shingle to Class 4 impact-resistant or to tile can double your number, and it's a deliberate choice, not a surprise.
3. Decking condition. Nobody knows what's under the old roof until tear-off. Rotted boards discovered underneath add sheathing, and an honest contractor photographs each one and shows it to you before replacing it.
4. Access. A two-story home, tight side yards, or landscaping the crew has to protect all add labor. A hard roof to reach is a slower roof to install.

Layers matter too: tearing off two old roofs costs more than one. None of these should be a mystery on your estimate; if a driver isn't spelled out in writing, ask why before you sign.

A real replacement price is a scope, not a number. Every ARP estimate includes the whole system, so the figure you approve is the figure you pay:

• Full tear-off of the existing roof and haul-off
• Deck inspection with photos, and any rotted board shown to you before it's replaced
• Synthetic underlayment (not felt paper)
• Ice-and-water shield in the valleys and around every penetration
• Drip edge on eaves and rakes, and a manufacturer-spec starter strip
• All new flashing: valleys, pipes, skylights, walls
• Ridge and hip caps
• A magnetic nail sweep of your entire yard
• The building permit, pulled in every market we serve
• Manufacturer warranty registration in your name within 30 days

That list is exactly where a too-good-to-be-true bid gets cheap. If you're seeing a full replacement priced well under the ranges above, something got left out: an overlay instead of a tear-off, felt instead of synthetic underlayment, reused flashing, or a permit that reappears later as a surprise line item.

The number on a roofing quote is the easy part — the scope underneath it is where you live or get burned. I see homeowners line up three bids, pick the lowest, and not realize bid number two included synthetic underlayment, ice-and-water shield in the valleys, drip edge on every eave, and a real starter strip — while the cheap one specced felt, no valley membrane, and cut-shingle starters. Same dollar figure on a different roof. Read the scope first.

Not sure you even need a full replacement yet? Start with the signs you need a new roof. If the wear is local and your deck is sound, repair cost may be the honest answer.

Often, yes, if the damage came from a storm and you file inside your policy's window. Insurance covers sudden damage like hail, wind, or a fallen limb. It does not cover ordinary wear, meaning a roof that simply reached the end of its life. That distinction is the whole claim, and it turns on documentation.

Two policy types decide your out-of-pocket. On a replacement-cost value (RCV) policy, you pay your deductible and the carrier covers the rest of the approved scope. On an actual-cash-value (ACV) policy, you pay the deductible plus depreciation. And if you're weighing the jump to Class 4 impact-resistant shingles, most Texas carriers offer a premium discount for them. Verify yours before you upgrade, because that discount often offsets the added cost within a few years.

One warning worth repeating: any contractor who offers to cover, waive, or "eat" your insurance deductible is violating Texas Insurance Code Chapter 707. It's illegal, and it's a reliable signal to close the door. If a roof is beyond a claim and the cost is the obstacle, monthly financing exists for exactly that situation. Ask about it at your assessment.

We're rarely the lowest bid, and we'd rather say so here than at your kitchen table.

The number that matters isn't the one on the estimate, it's the one you pay over the life of the roof. A little more for the right install is the cheapest money you'll spend on the house.

Family-owned and locally accountable, ARP is run by Randal Williams (COO) and his son Preston (President), the same father and son who sign the warranties. We hold GAF Certified Plus and Atlas PRO+ Platinum Select certifications, an A+ BBB rating, and CTRCA membership, across 5,000+ Texas roofing projects and 300+ five-star reviews.

When you're ready to see the install itself, here's exactly what the replacement process looks like, day by day.

You shouldn't have to become a roofing expert to make a $20,000 decision. Book a free assessment and we'll measure your roof, photograph what we find, and hand you a written scope with a real range, not a curbside guess. If it turns out you need a repair instead of a replacement, we'll tell you that too.

Book My Free Roof Assessment or call (210) 714-0040.

• UL 2218: the impact-test standard behind the Class 4 rating and the insurance premium credit.
• Texas Insurance Code Chapter 707: prohibits a contractor from paying or rebating an insurance deductible.

Manufacturer Certifications:

• GAF Certified Plus Contractor
• Atlas PRO+ Platinum Select Contractor

Industry Membership:

• BBB A+ Accredited
• CTRCA (Central Texas Roofing Contractors Association) Member